AAA and Role-based CLI view

Andres Franco — Mon, 11 Mar 2019 01:28:03 GMT

Hi all!

I´ve been practicing for CCNA Security. I´ve configured aaa authentication and authorization locally with radius server and local respectively. I´m also managing Role-based CLI views. The problem is when i issue the show running-config command once i´ve been authenticated to the router under a certain view (here p2p). The commands executes but does not show the running config, just like this:

R1#sh run

Building configuration...

Current configuration : 13 bytes

end

R1#

But if I issue the show start command it works perfectly. Any idea?. Here is an extract of my config

aaa authentication login default local

aaa authentication login AUTHENLOG group radius local

aaa authorization exec default local

username tecnico view p2p secret 5 $1$ZJ37$jO9UCzQbbCXGRjdjMeVsY/

parser view p2p

secret 5 $1$Iren$IcqqsMA.hhEX.H2pEFwXP1

commands configure include interface

commands exec include ping

commands exec include configure

commands exec include show running-config

commands exec include all show

Thanks in advance!

AF.

AAA and Role-based CLI view

lvlihui86 — Tue, 01 Nov 2011 07:12:41 GMT

yes,this is right,commands of view mode is depend that assign,the router get commands so little, the same to you

if you use privilege mode ，you can get command of priviege level one at least

topic AAA and Role-based CLI view in Network Access Control

AAA and Role-based CLI view

AAA and Role-based CLI view