topic ISE - User reauthentication in Network Access Control

ISE - User reauthentication

Jason van den Berg — Mon, 11 Mar 2019 02:04:31 GMT

Hi,

I am in the process of testing ISE. I have run into an issue when a user needs to reauthenticate the below popup that request aditional information happens to fast that you sometimes do not even notice it or able to click it in time to retype your credentials.

Is there anyway to delay this or a process to be able to type your details.

It is particularly annoying when you do not have the below enabled.

ISE - User reauthentication

Eduardo Aliaga — Sun, 13 May 2012 02:06:01 GMT

I don't think it's related to ISE. But we need more information. Are you using "wired" or "wireless" ? Could you show us the logs of ISE ?

ISE - User reauthentication

Jason van den Berg — Mon, 14 May 2012 06:48:59 GMT

The issue is not related to ISE per say.

When a user changes his/her password the popup appears as per my original post. This popup however dissapears 1-2 seconds later. Please keep in mind that ISE sends the authentication requests to an external identity source.

I am sure anyone else who setup 802.1x would get this issue where the popup is way to fast to re-enter your credetials after the password change. I added the 2nd screenshot on showing that you can enable it to automatically use your domain credentials. This however is not always feasable to have it automattically use the users domain credentials.