ISE wireless authorization (Based on AP location)

Mostafa.Ragab — Mon, 11 Mar 2019 07:34:25 GMT

Hello All,

I have ISE 2.0 integrated with Cisco AIR 5520 WLC. I want to authorize wireless dot1x users based on the AP location. (Assign a different wireless vlan for each building floor).

How can I do this ? , Or Is there is any attribute on ISE that points to the AP group?

Thanks in Advance.

Mostafa

You can change the Calling

Rahul Govindan — Mon, 27 Mar 2017 13:35:11 GMT

You can change the Calling Station ID to AP group on the controller. This is set under Security > AAA > Radius >Authentication. You can then use this Radius attribute to make decisions based on Calling station ID.

topic You can change the Calling in Network Access Control

ISE wireless authorization (Based on AP location)

You can change the Calling