topic Changing IP Address in ISE in Network Access Control

Changing IP Address in ISE

fatalXerror — Mon, 11 Mar 2019 07:22:19 GMT

Hi Guys,

Good Day!

I have an ISE installed in VM. I tried to change the IP address and it seems to be stock right after the stopping of services. Do you know why?

Thanks.

Is there any error message

Ravi Singh — Wed, 18 Jan 2017 12:44:44 GMT

Is there any error message you are getting? Please post

Procedure to Change IP Address

You have to login to the console, using ssh. Then you'll have a CLI to change the IP address or assign IP addresses to other interfaces. The ISE user guide section has a document describing the commands. Note: after changing the IP address the ISE application is restarted automatically.

I have the same issue when we

John Capobianco — Fri, 10 Mar 2017 18:30:48 GMT

I have the same issue when we say "Y" to automatically cycle the services the CLI hangs and never returns. We left it for hours and we cant get the CLI back.

There is no other way even if we assign a new IP to a different NIC the services want to automatically restart and hangs.

No error no logging nothing

Did you get your issue resolved?

Ok so when the CLI 'hangs' or

John Capobianco — Thu, 16 Mar 2017 18:34:48 GMT

Ok so when the CLI 'hangs' or is 'stuck' at the very end of the process you can use CONTROL-C to 'kill' / terminate the session. This will get you back to the CLI from there you can then write mem and reload the box / application start ISE

Worked for me