topic Re: Cisco ISE 2.2 Patch 10 breaks deployment .... in Network Access Control

Cisco ISE 2.2 Patch 10 breaks deployment ....

Frank Lothar Weber — Mon, 11 Mar 2019 08:49:51 GMT

Hi, all.

We installed 2.2 patch 10 a few days ago, since then thousands of alarm messages were thrown, like:

"Replication failed", "health status unavailable", etc., all sounding like the nodes could not see each other anymore.

In addition to that, the "System Summary" applet on the deployment homepage showed all nodes in grey, all with

"no Data available" .... function of the deployment did not seem affected at all though....

After rollback of patch 10 (to patch 9), everything seems back to normal, no large numbers of the alarms I mentioned and

the system summary applet shows normal stuff again, too.

Something like that never happened with any other patch before (1-9), I strongly believe that this was not supposed to happen

with patch 10 either. 🙂

Anybody had a similar experience ???

Rgs

Frank

Re: Cisco ISE 2.2 Patch 10 breaks deployment ....

Jason Kunst — Tue, 25 Sep 2018 10:58:41 GMT

Make sure you contact tac and report issue so it can be debugged

Re: Cisco ISE 2.2 Patch 10 breaks deployment ....

anthonylofreso — Tue, 25 Sep 2018 12:38:24 GMT

I was browsing the communities this morning to see if there had been anybody to install patch 10 yet. Sorry to hear this, you'll have to let us know what you figure out after engaging TAC.

Also, you may get more visibility posting here instead - https://community.cisco.com/t5/identity-services-engine-ise/bd-p/5301j-disc-ise

Re: Cisco ISE 2.2 Patch 10 breaks deployment ....

Jason Kunst — Tue, 25 Sep 2018 12:48:41 GMT

Correct posting in ISE is more effective

Re: Cisco ISE 2.2 Patch 10 breaks deployment ....

Frank Lothar Weber — Tue, 25 Sep 2018 12:54:15 GMT

Yepp, my bad, I posted in the wrong place, sorry .....