topic Re: Catalyst WS-C2960G-48TC-L and dot1x in Network Access Control

Catalyst WS-C2960G-48TC-L and dot1x

alexandru.cacean — Mon, 11 Mar 2019 00:40:29 GMT

hello, i have a WS-C2960G-48TC-L switch with (C2960-LANBASEK9-M), Version 12.2(53)SE2 IOS. I need to configure on his interfaces dot1x, but is not active all de options on the interface dot1x submenu:

C2960G(config-if)#dot1x ?
credentials     Credentials profile configuration
default         Configure Dot1x with default values for this port
max-reauth-req Max No.of Reauthentication Attempts
max-req         Max No.of Retries
max-start       Max No. of EAPOL-Start requests
pae             Set 802.1x interface pae type
supplicant      Configure supplicant parameters
timeout         Various Timeouts

i can't find the : port-control, mac-auth-bypass

tell me please what is the problem

Re: Catalyst WS-C2960G-48TC-L and dot1x

Tiago Antunes — Tue, 28 Dec 2010 09:29:45 GMT

Hi,

Please note that the dot1x commands have changed in version 12.2(50) and later.

Here you can find the new commands:

http://www.ciscosystems.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_53_se/configuration/guide/sw8021x.html#wpmkr1468843.

HTH,
Tiago

If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.

Re: Catalyst WS-C2960G-48TC-L and dot1x

alexandru.cacean — Tue, 28 Dec 2010 11:25:03 GMT

thanks, new version of command is authentication port-control