topic Re: ACS Framed-Interface-id in Network Access Control https://community.cisco.com/t5/network-access-control/acs-framed-interface-id/m-p/1330379#M357785 <HTML><HEAD></HEAD><BODY><P>Hi JK</P><P></P><P>Here is an additional question for you if you can help.</P><P></P><P>To use the ACS Server for IPv6 DHCP assigments, the documentaion states that you need to create an additional username which has -dhcpv6 added. What would be the password for this account be, have tried everything so far, i must be missing something completly. As you may know, you can have blank passwords in ACS.</P><P></P><P>Cheers</P><P>Derek</P></BODY></HTML> Tue, 08 Sep 2009 14:38:08 GMT derekgaff 2009-09-08T14:38:08Z ACS Framed-Interface-id https://community.cisco.com/t5/network-access-control/acs-framed-interface-id/m-p/1330377#M357783 <P>Can anybody tell me if the RADIUS Attribute "Framed-Interface-id" as per RFC 3162 is available within Cisco ACS. I need to use this to assign specific IPv6 addresses to PPP Clients.</P> Sun, 10 Mar 2019 23:40:35 GMT https://community.cisco.com/t5/network-access-control/acs-framed-interface-id/m-p/1330377#M357783 derekgaff 2019-03-10T23:40:35Z Re: ACS Framed-Interface-id https://community.cisco.com/t5/network-access-control/acs-framed-interface-id/m-p/1330378#M357784 <HTML><HEAD></HEAD><BODY><P>Hi,</P><P></P><P>ACS would support the RADIUS attributes used for IPv6 network access described in RFC 3162...CORRECT !</P><P></P><P>Radius attribute "framed-interface-id" is not supported by Cisco secure ACS version 4.x.</P><P></P><P>Initial support for IPv6 will be in 5.1 release.</P><P></P><P>HTH</P><P></P><P>Regards,</P><P>JK</P></BODY></HTML> Mon, 07 Sep 2009 15:18:13 GMT https://community.cisco.com/t5/network-access-control/acs-framed-interface-id/m-p/1330378#M357784 Jatin Katyal 2009-09-07T15:18:13Z Re: ACS Framed-Interface-id https://community.cisco.com/t5/network-access-control/acs-framed-interface-id/m-p/1330379#M357785 <HTML><HEAD></HEAD><BODY><P>Hi JK</P><P></P><P>Here is an additional question for you if you can help.</P><P></P><P>To use the ACS Server for IPv6 DHCP assigments, the documentaion states that you need to create an additional username which has -dhcpv6 added. What would be the password for this account be, have tried everything so far, i must be missing something completly. As you may know, you can have blank passwords in ACS.</P><P></P><P>Cheers</P><P>Derek</P></BODY></HTML> Tue, 08 Sep 2009 14:38:08 GMT https://community.cisco.com/t5/network-access-control/acs-framed-interface-id/m-p/1330379#M357785 derekgaff 2009-09-08T14:38:08Z