Enabling Web Interface

alexandre.raffin1 — Mon, 11 Mar 2019 06:45:03 GMT

Hello,

I have 2 Cisco Aironet 1700 Series. I have been able to access the web interface on both of them at some point. However, after unplugging and plugging back the first one, I couldn't access the web interface anymore.

I can access them through ssh. I checked both configurations and they are nearly the same. The results are the same except for a few differences :

command 1: show run | i ip http

result (same for both):

ip http server

no ip http secure-server

ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag

command 2: show interfaces

result (just an extract):

Dot11Radio0 is up, line protocol is up

Dot11Radio0.11 is up, line protocol is up (only for the first AP, the one i can't access the web interface)

Dot11Radio1 is up, line protocol is up

I tried:

reload

AND

while in global configuration mode: ip http authentication local (also tried enable)

ip http server

Also, the Cisco, Cisco user exists for both.

When running nmap, the state of the port 80 is sometimes filtered instead of open. Also, I can sometimes be prompted to enter a username and password but Cisco, Cisco does not work.

Any command I could run to pinpoint the problem? Any command I should run to enable the web interface?

Thanks,

Alexandre

topic Enabling Web Interface in Network Access Control

Enabling Web Interface