topic Re: Secure Access Control Server 1112 questions in Network Access Control

Secure Access Control Server 1112 questions

butler.brad — Sun, 10 Mar 2019 23:22:13 GMT

We have the ACS 1112 that we have never taken the time to setup until now.

I realize this is end-of-life, but we only need it to audit logins for a few local core devices and a few remote devices across the WAN.

I can't seem to find IOS upgrade for this device or any setup config info.

Any help would be appreciated.

Re: Secure Access Control Server 1112 questions

ansalaza — Wed, 04 Mar 2009 16:34:11 GMT

This is the download link for ACS SE patches:

http://www.cisco.com/cgi-bin/tablebuild.pl/acs-soleng-3des

I suppose it all depends where you're at and where you'll like to go.

Upgrade Scenarios

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.2/installation/guide/solution_engine/upgap.html#wp1112633

If you have a software contract, the base images can be provided by TAC.

Re: Secure Access Control Server 1112 questions

butler.brad — Wed, 04 Mar 2009 20:31:26 GMT

Thank you, very much appreciated.

I inherited this thing and having a hard time finding documentation on setting it up.

It is not allowing me to console in and when I put a monitor on it and bypass the boot by hitting delete it's asking for a password? No clue what they put on it. I'm just trying to see what ver. this thing is @

Re: Secure Access Control Server 1112 questions

ansalaza — Wed, 04 Mar 2009 20:39:14 GMT

Is it the BIOS Password?

You can find the defaults here:

Password Recovery Procedure for the Cisco Secure ACS Solution Engine

http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_password_recovery09186a00801ece5f.shtml#bios

If this is not in use...you might want to format/re-image the device and start from scratch...although you need the 1112 Recovery CD.

Re: Secure Access Control Server 1112 questions

butler.brad — Wed, 04 Mar 2009 20:50:13 GMT

yes the bios although I really can get by without it right now.

The recovery cd, yes this would be what I need.

....so what is the trick to get the console port to work? Just standard 9600 baud 8bit?

-thanks