topic Re: NEW TO ACS 5.0 in Network Access Control

NEW TO ACS 5.0

ericohermoso — Sun, 10 Mar 2019 23:51:30 GMT

I am new to cisco security. I have problem in ACS 5.0. Can somebody guide me in configuring the ACS or I Really need book that has step by step procedure to adding users ,network device group, policies and access policies...plss

Re: NEW TO ACS 5.0

nagabhushana.k — Wed, 23 Dec 2009 08:12:37 GMT

Hi,

Depending on the requirement you can go ahead with configuration. I mean, ACS can be used to grant users access to devices' administration (ex: administration of Routers, Switches etc) and also for Network access (ex. access to network resources).

You can refer to following URLs:

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_express/5.0/roadmap/xpguide.html#wp1029166

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_express/5.0/user/guide/users.html

I hope it help you to configure ACS. All the best.

Regards,

Bhushan

Re: NEW TO ACS 5.0

Ganesh Hariharan — Thu, 31 Dec 2009 16:14:56 GMT

Hi,

Check out the below link on complete installation and configuration guide for Cisco ACS 5.0

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_express/5.0/installation/guide/instllgd.pdf

Hope this helps out your query !!

Regards

Ganesh.H

Re: NEW TO ACS 5.0

ansalaza — Thu, 31 Dec 2009 16:37:47 GMT

These are the links for the general ACS 5.X configuration:

End-User Guides

http://www.cisco.com/en/US/products/ps9911/products_user_guide_list.html

Install and Upgrade Guides

http://www.cisco.com/en/US/products/ps9911/prod_installation_guides_list.html

It would be recommended to read the guide, start working your way up, once you have some issues then let us know so we can try to help you out with what we can...

HTH

Re: NEW TO ACS 5.0

ericohermoso — Thu, 04 Feb 2010 06:43:12 GMT

thanks guys, from the sites that you have given i started the acs configuration, that works fine. But whenever i use enable i got an error message like Authentication failed.

My configuration goes like this

aaa new-model
aaa authentication login telnet_lines group tacacs+

aaa authentication enable default group tacacs+ enable----------when i use this command i got AUTHENTICATION FAILED

enable password cisco

aaa session-id common
tacacs-server host 172.17.11.19 key cisco

line vty 0 4
authorization commands 15 telnet_lines
authorization exec telnet_lines
login authentication telnet_lines

guys, I am using ACS 5.0. What should i do with this?

thanks