topic Re: ACS Shell Cmds stopped working in Network Access Control https://community.cisco.com/t5/network-access-control/acs-shell-cmds-stopped-working/m-p/1124795#M389226 <HTML><HEAD></HEAD><BODY><P>What do does the fail attempts log say? You may also want to run "debug aaa author" and "debug tacacs author" and see what is sent and returned from ACS.</P></BODY></HTML> Fri, 09 Jan 2009 21:54:01 GMT jhillend 2009-01-09T21:54:01Z ACS Shell Cmds stopped working https://community.cisco.com/t5/network-access-control/acs-shell-cmds-stopped-working/m-p/1124794#M389169 <P>I have a group in ACS that has limited level 15 access to NDGs. Under Unmatch Commands I have "configure", with "permit terminal" under unmatched arugs. This has been working fine for months.</P><P></P><P>A week ago,this command stopped working. I've tried removing and re adding the command but no luck.</P><P></P><P>Any ideas??</P><P>This is ACS 3.3(4) on Windows platform.</P> Sun, 10 Mar 2019 23:15:41 GMT https://community.cisco.com/t5/network-access-control/acs-shell-cmds-stopped-working/m-p/1124794#M389169 rkallas 2019-03-10T23:15:41Z Re: ACS Shell Cmds stopped working https://community.cisco.com/t5/network-access-control/acs-shell-cmds-stopped-working/m-p/1124795#M389226 <HTML><HEAD></HEAD><BODY><P>What do does the fail attempts log say? You may also want to run "debug aaa author" and "debug tacacs author" and see what is sent and returned from ACS.</P></BODY></HTML> Fri, 09 Jan 2009 21:54:01 GMT https://community.cisco.com/t5/network-access-control/acs-shell-cmds-stopped-working/m-p/1124795#M389226 jhillend 2009-01-09T21:54:01Z