https://community.cisco.com/t5/network-access-control/cts-manual-command-on-port-channel/m-p/2860534#M39866 <P>I am trying to enable TrustSec in my environment. I need to get the 'cts manual' command on all my uplinks in order to propagate SGTs. My issue is that all my uplinks are port-channels. You can't add cts manual to port-channels. So far, I've had to remove the interfaces from the port-channels, add the commands on both sides, then re-add the interfaces to the port-channel. This causes an outage. Is there a better way to do this? Thanks.</P> Mon, 11 Mar 2019 06:46:53 GMT Josh Morris 2019-03-11T06:46:53Z https://community.cisco.com/t5/network-access-control/cts-manual-command-on-port-channel/m-p/2860534#M39866 <P>I am trying to enable TrustSec in my environment. I need to get the 'cts manual' command on all my uplinks in order to propagate SGTs. My issue is that all my uplinks are port-channels. You can't add cts manual to port-channels. So far, I've had to remove the interfaces from the port-channels, add the commands on both sides, then re-add the interfaces to the port-channel. This causes an outage. Is there a better way to do this? Thanks.</P> Mon, 11 Mar 2019 06:46:53 GMT https://community.cisco.com/t5/network-access-control/cts-manual-command-on-port-channel/m-p/2860534#M39866 Josh Morris 2019-03-11T06:46:53Z https://community.cisco.com/t5/network-access-control/cts-manual-command-on-port-channel/m-p/2860535#M39868 <P>Platform: 3850 IPBase</P> <P>I was able to work around the problem by creating a new port-channel, removing a member port from the old PC, modifying it, and adding to the new PC.&nbsp; The far end is VPC&nbsp;pair of Nexus 5k.</P> Tue, 04 Oct 2016 16:52:29 GMT https://community.cisco.com/t5/network-access-control/cts-manual-command-on-port-channel/m-p/2860535#M39868 lburleso 2016-10-04T16:52:29Z