topic Re: Replication not working just for AAA clients in NDG in Network Access Control

Replication not working just for AAA clients in NDG

jcarvalh — Sun, 10 Mar 2019 23:26:26 GMT

Hello.

I have configured replication between two ACSv4.2.

Everything worked fine except the AAA clients belonging to NDGs.

I am allowing tcp/2000 in FWSM an I am not using NAT.

The rest of the configs seem to be OK since I was able to replicate all the rest.

Does anyone have any ideia about this problem?

Thanks in advance,

Joao Carvalho

Re: Replication not working just for AAA clients in NDG

Jagdeep Gambhir — Wed, 15 Apr 2009 15:02:55 GMT

Please go to ACS--->Interface configuration--->Advanced option--->Enable NDG -->Submit.

Check now ...NDG's should be there.

Regards,

~JG

Do rate helpful posts

Re: Replication not working just for AAA clients in NDG

jcarvalh — Thu, 16 Apr 2009 07:44:46 GMT

Hello.

NDG were already active.

NDG from primary ACS apear on secondary, however their content do not (AAA clients).

Joao Carvalho

Re: Replication not working just for AAA clients in NDG

sahmedshahcsd — Thu, 16 Apr 2009 12:24:43 GMT

Do verify the required replication components are selected on primary ACS such as User Database and Configurations etc.,check boxes are selected in send option and the same components are selected for receive option check box in secondary ACS.

Hope this helps

Ahmed

Re: Replication not working just for AAA clients in NDG

jcarvalh — Thu, 16 Apr 2009 13:58:22 GMT

Hello.

That was also done. It looks like a mirror 🙂

Thanks,

Joao

P.S. - I am going to install ACS again, don't see any other problem.

Re: Replication not working just for AAA clients in NDG

sahmedshahcsd — Thu, 16 Apr 2009 16:55:09 GMT

Moreover Network Configuration device table can be backed up from the running ACS and can be restored on another ACS with missing NDG's under Backup and Restore.

Configuration of replication between ACS's will be followed.

HTH

Ahmed