topic ACSv4.2 in Network Access Control https://community.cisco.com/t5/network-access-control/acsv4-2/m-p/1066418#M405999 <P>Has anyone seen this before? Interface configuration options, under select, There are only two options User_data_configurations and Advanced Options - I have re-image this box twice and same results. Thank you... See image attached</P><P></P> Sun, 10 Mar 2019 23:08:02 GMT mguzman4158 2019-03-10T23:08:02Z ACSv4.2 https://community.cisco.com/t5/network-access-control/acsv4-2/m-p/1066418#M405999 <P>Has anyone seen this before? Interface configuration options, under select, There are only two options User_data_configurations and Advanced Options - I have re-image this box twice and same results. Thank you... See image attached</P><P></P> Sun, 10 Mar 2019 23:08:02 GMT https://community.cisco.com/t5/network-access-control/acsv4-2/m-p/1066418#M405999 mguzman4158 2019-03-10T23:08:02Z Re: ACSv4.2 https://community.cisco.com/t5/network-access-control/acsv4-2/m-p/1066419#M406000 <HTML><HEAD></HEAD><BODY><P>Here is a jpg of the error - thanks </P><P></P><P> </P><P></P></BODY></HTML> Mon, 13 Oct 2008 19:23:53 GMT https://community.cisco.com/t5/network-access-control/acsv4-2/m-p/1066419#M406000 mguzman4158 2008-10-13T19:23:53Z Re: ACSv4.2 https://community.cisco.com/t5/network-access-control/acsv4-2/m-p/1066420#M406001 <HTML><HEAD></HEAD><BODY><P>Rest option will show up once you add any aaa-client. </P><P></P><P>Like if you add any switch using radius ietf, then radius will show up in interface configuration.</P><P></P><P></P><P>Regards,</P><P>~JG</P><P></P><P>Do rate helpful posts</P></BODY></HTML> Mon, 13 Oct 2008 20:37:48 GMT https://community.cisco.com/t5/network-access-control/acsv4-2/m-p/1066420#M406001 Jagdeep Gambhir 2008-10-13T20:37:48Z