topic Re: EAP type not configured in Network Access Control

EAP type not configured

mirboukai — Sun, 10 Mar 2019 22:21:51 GMT

i have an ACS 1113 ....

i have installed and configured the certificate... and trusted the CA certificate... also i configured the global authentication (enable the PEAP ,EAP-TLS)

no when i try to authenticate (by the wireless) i get failed to authenticate

when checking the ACS failed attempts i find the failure code

- EAP type not configured-

i don?t know why its happing....

but every thing is configured...

Re: EAP type not configured

Jagdeep Gambhir — Thu, 30 Aug 2007 00:18:33 GMT

Please make sure on ACS > Network Access Profiles >

Make sure we have "Grant access using global configuration,when no profile matches" option

selected.

Also make sure on ACS > ACS Certificate Setup > Install ACS Certificate >

Make sure a certificate is installed, if it is installed then click cancel.

Also go to ACS > System Configuration > Global Authentication Setup > Make sure under "PEAP" we have checked "Allow EAP-MSCHAPv2" and/or "Allow EAP-GTC" as applicable.

Regards,

~JG

Re: EAP type not configured

mirboukai — Thu, 30 Aug 2007 07:35:15 GMT

thank you

the "Grant access using global configuration,when no profile matches" option was not selected.

could you please give me a brief of why do we configure the NAP..

Re: EAP type not configured

Jagdeep Gambhir — Thu, 30 Aug 2007 11:37:12 GMT

Hi,

Please check this link that explains about NAP,

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.0/user/guide/sp.html

Regards,

~JG