topic Re: ACS appliance multiple interface usage in Network Access Control

ACS appliance multiple interface usage

dehghan — Sun, 10 Mar 2019 23:00:52 GMT

Is it possible for me to use the two interfaces that are available on the 1113 box? I want to connect both of these interfaces to two seperate network segments. I did not find any thing specific in the Cosole except the set ip that would only config one interface.

thanks

Re: ACS appliance multiple interface usage

dhananjoy chowdhury — Tue, 05 Aug 2008 10:43:44 GMT

You can use only one.

Your Cisco 1113 system has two integrated 10/100/1000-megabit-per-second (Mbps) Ethernet connectors. ACS SE supports the operation of either Ethernet connector, but not both connectors.

For more check here

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.1/installation/guide/solution_engine/ovrvuap.html#wp1054065

Re: ACS appliance multiple interface usage

sarmohan — Tue, 05 Aug 2008 10:59:39 GMT

The Cisco Secure ACS Appliance supports the operation of only one Ethernet connector at a time. Concurrent operation of both Ethernet connectors is not supported.

Thanks,

Saravanan

Re: ACS appliance multiple interface usage

dehghan — Tue, 05 Aug 2008 11:07:20 GMT

Is there any plan for the support of the second interface in later releases? This second interface might become very usefull sometimes.

thanks

Re: ACS appliance multiple interface usage

Jagdeep Gambhir — Tue, 05 Aug 2008 16:47:34 GMT

No. as of now there is no plan to make BOTH NIC operational at a same time.

Regards,

~JG