topic Re: User without (blank) password in Network Access Control

User without (blank) password

Hubert Mayr-Kneilling — Sun, 10 Mar 2019 21:52:38 GMT

Hello,

I'm trying to create a special group of Clients to authenticate via ACS-Server without a password.

Creating a user in ACS without a password leads to the error-message "Cannot set blank password for a user unless they are in a VoIP group".

If I try to put this users to a group with "Voice-over-IP Support" enabled I receive the following error message in the Failed-Attempts report: "Access denied to Voice-over-IP group".

Anybody any ideas?

regards

HMK

Re: User without (blank) password

darpotter — Wed, 13 Dec 2006 22:14:35 GMT

As I recall VoIP authentication is a little odd.

The authentication request MUST have a password included, and it must have a value of "" ie empty.

Otherwise it'll fail. Dont think there are any other restrictions.

Re: User without (blank) password

Hubert Mayr-Kneilling — Thu, 14 Dec 2006 10:57:34 GMT

Hello,

thanks for your response. What do you mean with "a little odd". I could not find any useful documentation on this feature. Could you perhaps provide me with a link other than the ACS User Guide.

regards

HMK