topic Re: ACS Solution Engine-Doesn't keep IP address. in Network Access Control

ACS Solution Engine-Doesn't keep IP address.

phowlett549 — Sun, 10 Mar 2019 21:33:30 GMT

Hello, I am installing the latest version of the ACS appliance. I connected to the serial port and configured all the basics but the IP address/mask/gateway are not being retained. The hostname/DNS servers/new login are though.

After entering the IP info ['set IP'] I am asked if I want to test the network, I select no and the services stop and then restart. When I issue a show the IP address is set to 0.0.0.0.

If I say yes to network test I can Ping OK but when the services stop and start again the IP address isn't retained!

Anybody any ideas?

Thank you in advance.

Re: ACS Solution Engine-Doesn't keep IP address.

a-vazquez — Wed, 03 May 2006 15:28:41 GMT

Configure an IP address filter on ACS Windows and ACS Solution Engine to limit the exposure of these vulnerabilities. From within the ACS GUI, browse to Administration Control > Access Policy to limit access to only the machines that need to administer the ACS remotely.

http://www.cisco.com/warp/public/707/cisco-sa-20040825-acs.shtml

Re: ACS Solution Engine-Doesn't keep IP address.

gbressanin — Tue, 18 Jul 2006 11:02:57 GMT

Have you solved that issue? I also have the same with release 4.0.

Regards

Giovanni

Re: ACS Solution Engine-Doesn't keep IP address.

andrew.brazier — Wed, 02 Aug 2006 09:54:18 GMT

Had the same issue with a new ACS4 SE yesterday. Logged back in via the console and used the set ip command to re-enter the IP details, did the ping test and saved settings which were then retained.

Re: ACS Solution Engine-Doesn't keep IP address.

Aaron Harrison — Tue, 12 Sep 2006 19:02:38 GMT

The IP address/gateway/subnet mask settings all show up as 0.0.0.0 if your interface is down at that moment - this is often confusing...

Regards

Aaron

Re: ACS Solution Engine-Doesn't keep IP address.

pvanvuuren — Wed, 13 Sep 2006 07:11:56 GMT

Hi all

I found by mere chance that our ASC SE needs that IP interface up (Layer 1) when manually setting the IP. So, plug it into a switch or maybe use a X-over cable to your laptop/PC. Then set the IP manually. Let us know.

Re: ACS Solution Engine-Doesn't keep IP address.

hiddink — Tue, 22 May 2007 12:20:35 GMT

I had also experienced as you had.

I drived me crazy and so I re-installed acs program using restore Cd which it comes with

new appliance.

It is working well and problems had gone.

try it.