sub interface privilege level?

kkeen — Sun, 10 Mar 2019 21:15:49 GMT

For the life of me, i cannot get my users to be able to create & edit subinterfaces using privilege levels

This is my current privilege setup

privilege ip-vrf level 7 rd

privilege vpdn-group level 7 description

privilege interface level 7 pvc

privilege interface level 7 tunnel mode

privilege interface level 7 tunnel destination

privilege interface level 7 tunnel source

privilege interface level 7 tunnel

privilege interface level 7 atm-dxi pvc

privilege interface level 7 atm-dxi

privilege interface level 7 atm pvc

privilege interface level 7 atm

privilege interface level 7 service-policy

privilege interface level 7 ip access-group

privilege interface level 7 ip address

privilege interface level 7 ip vrf forwarding

privilege interface level 7 ip vrf

privilege interface level 7 ip

privilege interface level 7 encapsulation

privilege interface level 7 description

privilege configure level 7 ip route

privilege configure level 7 ip local pool

privilege configure level 7 ip local

privilege configure level 7 interface

privilege configure level 7 policy-map

privilege configure level 7 ip vrf

privilege configure level 7 ip

privilege exec level 7 copy running-config startup-config

privilege exec level 7 copy running-config

privilege exec level 7 copy

privilege exec level 7 telnet

privilege exec level 7 write memory

privilege exec level 7 write

privilege exec level 7 traceroute

privilege exec level 1 ping atm interface

privilege exec level 1 ping atm

privilege exec level 1 ping

privilege exec level 7 configure terminal

privilege exec level 7 configure

privilege exec level 7 show policy-map

privilege exec level 1 show vpdn session

privilege exec level 1 show vpdn tunnel

privilege exec level 1 show vpdn

privilege exec level 1 show ip route

privilege exec level 1 show ip

privilege exec level 1 show users

privilege exec level 1 show version

privilege exec level 7 show startup-config

privilege exec level 1 show running-config

privilege exec level 1 show

privilege exec level 7 clear interface

privilege exec level 7 clear

Re: sub interface privilege level?

thomas.chen — Tue, 16 Aug 2005 17:57:59 GMT

You will have to give the "privilege mode interface" command also to enable the interface configuration mode.

Re: sub interface privilege level?

kkeen — Tue, 16 Aug 2005 21:33:15 GMT

That command isn't valid my friend

XXX-rtr-08(config)#privilege mode ?

% Unrecognized command

XXX-rtr-08(config)#privilege mode ^Z ^

% Invalid input detected at '^' marker.

XXX-rtr-08#sh ver

Cisco Internetwork Operating System Software

IOS (tm) 7200 Software (C7200-JS-M), Version 12.3(6a), RELEASE SOFTWARE (fc4)

topic Re: sub interface privilege level? in Network Access Control

sub interface privilege level?

Re: sub interface privilege level?

Re: sub interface privilege level?