topic Re: ACS Radius key return in Network Access Control https://community.cisco.com/t5/network-access-control/acs-radius-key-return/m-p/399766#M432515 <HTML><HEAD></HEAD><BODY><P>It doesn't return them by default.</P><P></P><P>After adding in your NAS as a "Radius (Cisco IOS/PIX)" device, go under Interface Configuration - Radius (Microsoft) and check the attributes you want, either on a Group and/or User basis. Then go under the group or the user, scroll down to where the attributes appear and check them so that they're returned.</P></BODY></HTML> Thu, 10 Mar 2005 04:03:34 GMT gfullage 2005-03-10T04:03:34Z ACS Radius key return https://community.cisco.com/t5/network-access-control/acs-radius-key-return/m-p/399765#M432514 <P>Does the Cisoc ACS return the MS-MPPE-SND-KEY and MS-MPPE-RCV-KEY by default? I have a gateway that says this is required. If not where is this changed in the ACS server?</P> Sun, 10 Mar 2019 21:03:02 GMT https://community.cisco.com/t5/network-access-control/acs-radius-key-return/m-p/399765#M432514 randyclark 2019-03-10T21:03:02Z Re: ACS Radius key return https://community.cisco.com/t5/network-access-control/acs-radius-key-return/m-p/399766#M432515 <HTML><HEAD></HEAD><BODY><P>It doesn't return them by default.</P><P></P><P>After adding in your NAS as a "Radius (Cisco IOS/PIX)" device, go under Interface Configuration - Radius (Microsoft) and check the attributes you want, either on a Group and/or User basis. Then go under the group or the user, scroll down to where the attributes appear and check them so that they're returned.</P></BODY></HTML> Thu, 10 Mar 2005 04:03:34 GMT https://community.cisco.com/t5/network-access-control/acs-radius-key-return/m-p/399766#M432515 gfullage 2005-03-10T04:03:34Z