Per-user NAT IP address assignment

antarias — Sun, 10 Mar 2019 14:52:09 GMT

Hello all,

I need to perform a per-user NAT translation and can't figure out if this can be accomplished with PIX and ACS :

When an authenticated user gets access to my inside network, I need to perform NAT to assign each one an specified IP address, maybe storing the address in each user or group profile in ACS.

This is because of requirements of a web application inside the firewall, which performs authentication based on IP -no way to change this app.

Any suggestions, on whether this can be accomplished or definitely not, would be very appreciated.

Thanks a lot.

A. Arias.

Re: Per-user NAT IP address assignment

mchin345 — Thu, 17 Jun 2004 14:56:11 GMT

Well according to this document you can authenticate per VPN may be your case could also be possible,

http://www.cisco.com/warp/customer/110/pixcryaaa52.html

topic Per-user NAT IP address assignment in Network Access Control

Per-user NAT IP address assignment

Re: Per-user NAT IP address assignment