topic Re: simple AAA issue in Network Access Control

simple AAA issue

gopal_voip — Sun, 10 Mar 2019 14:41:25 GMT

i have a pix 506(6.2) and cisco ACS 3.0 windows2000 server with sp4, my only issue is that when i configure PIX ,basically from PDM and i make a simple username say X and put the password in the first password box for cisco secure database which says " Cisco secure for PAP " , and when i do http the authentication prompt appears and after putting name/password it pops 3 times in 10 seconds and then says AUTH failed...where am i going wrong ..no fancy features..just BASIC user authentication...it just wont go....thanx in advance..

shukky

Re: simple AAA issue

umedryk — Mon, 08 Mar 2004 15:28:13 GMT

As what is written on the documentation of the ACS for windows. Only service packs 1 and 2 are supported.

Please check out this link for more information regarding this.

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacs4nt/csnt30/rn301.htm#1111032

Re: simple AAA issue

gopal_voip — Tue, 09 Mar 2004 08:51:08 GMT

thank you friend, i did it in sp2 and its working , with my heart-felt appreciation , pls accept my second query:

if i put authorization syntax in pix, then i have to give my password 3 times, after which it says AUTHEN failed, but in ..." show uauth " command it show the user is authenticated thus not authorized, so as of now my network is going on authentication but not authorization , moment i put authorize command , it stops browzing , and only authen , workz fine.

regards

shukky