topic Re: Shell Command Authorization Failure in Network Access Control

Shell Command Authorization Failure

emily — Sun, 10 Mar 2019 20:58:58 GMT

I just implement new ACS server , I want to using shell authorization command set to restrict every privilege level on network device command , I found it not workable

I had add a username "test" , it belong to group "5" , and assign shell authorization command set with "Privilege10"

I don’t know what wrong with this issue

Re: Shell Command Authorization Failure

nchopra — Tue, 25 Jan 2005 07:32:48 GMT

Hi..

Please check the following on router config:

1. Authorization commands on router?

2. Priv Level access on router (defined or not)?

Re: Shell Command Authorization Failure

emily — Wed, 26 Jan 2005 02:02:34 GMT

Thanks for you reponse

1. I have authorization commands on route , you can check previous attached

2. I didn't define any priv level on router

could you give me any adverse or positive infomation

Re: Shell Command Authorization Failure

nchopra — Thu, 27 Jan 2005 05:06:47 GMT

Hi Emily,

Please refer to the following Cisco Link, which will guide you through the configuration on Router:

http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a008009465c.shtml

Thanx & Regards.