topic Re: [pix command authorization] in Network Access Control

[pix command authorization]

Carlos A. Silva — Sun, 10 Mar 2019 14:18:57 GMT

hi:

i followed this link to a 't' and still i can get this thing to work

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00800949d6.shtml

of course what i'm trying to achieve is to create either a group or a user (at this point i don't care) that can only do show commands and another set that can configure and above.

does anybody know if there is a trick to this webpage?

btw, i'm using acs3.1 for win and pixos 6.2.2

any help would be greatly appreciated.

regards,

Re: [pix command authorization]

mhoda — Thu, 22 May 2003 05:01:21 GMT

Hi,

The document is accurate ! I have tested this features and it works great. I would say the trickiest part is to properly define the coomand and arguments properly on ACS.

If you can provide the AAA portion of the config as well as the sequence of the commands of arguments you have defineds, I can point you to the right direction.

Also, please ensure this, I saw many ingored this line:

3. Set Max Privilege for any AAA Client to Level 15, and choose the enable password scheme for the user (which could involve configuring a separate enable password) and click Submit.

Again, please provide the aaa portion of the config and commands/args logic you have defined. Thanks,

Mynul

Re: [pix command authorization]

Carlos A. Silva — Thu, 22 May 2003 13:58:53 GMT

hi, mynul:

first of all, thanks!

-no, i did not miss setting the max priviledge for the aaa client to level 15.

-the pix configuration is(the relevant part):

aaa-server TACACS+ protocol tacacs+

aaa-server TACACS+ (inside) host 172.16.10.5 cisco timeout 10

aaa authentication telnet console TACACS+

aaa authorization command TACACS+

-acs config: (will try to explain)

(all of this is on a user profile)

*under TACACS ENABLE CONTROL

max priviledge for any aaa client is checked and set to 15

*under TACACS ENABLE PASSWORD

this is checked and i used a different passwd

*under SHELL COMMAND AUTHORIZATION SET

per user command authorization is checked

unmatched cisco ios commands is checked on deny

theh i have the same for 2 commands"

command is checked

the commands are 'enable', unlisted arguments permit is checked

'show', unlisted arguments is checked under permit and 'permit config'

i hope this was clear enough, if you want i can email captures of the screens. my email is carlos@mnet.com.mx.

thanks a lot!

Re: [pix command authorization]

mhoda — Fri, 23 May 2003 04:09:52 GMT

Carlos,

Sent an e-mail for the screen captures ! Please reply. Thanks,

Mynul