topic Re: Cisco ISE Load on SNS-3615 in Network Access Control

Cisco ISE Load on SNS-3615

MEWO Cedrick — Mon, 07 Oct 2019 14:46:47 GMT

Hello team, I purchased two Cisco SNS-3615 for my end customer and in the BOM I have this option "SW-36X5-ISE-K9(Cisco ISE Software Load on SNS-36x5-K9 appliance) and want to confirm if the software is already loaded on the appliance or I have to download on software website for deployment?

Please waiting for your feedback.

Best Regards.

Re: Cisco ISE Load on SNS-3615

Damien Miller — Mon, 07 Oct 2019 15:12:05 GMT

The 3615 will ship with ISE 2.6 installed and ready for setup. When it arrives you will have to access it via keyboard/monitor unless the CIMC gets a DHCP address.

Once you have access to the CIMC you can use the HTML KVM to run through the ISE setup script.

Re: Cisco ISE Load on SNS-3615

Jason Kunst — Mon, 07 Oct 2019 15:23:53 GMT

Please also check the admin and setup guides

http://cs.co/ise-guides
https://www.cisco.com/c/en/us/support/security/identity-services-engine/products-installation-guides-list.html

Re: Cisco ISE Load on SNS-3615

MEWO Cedrick — Mon, 07 Oct 2019 15:50:05 GMT

Thanks Damien for your quick feedback.

Re: Cisco ISE Load on SNS-3615

MEWO Cedrick — Mon, 07 Oct 2019 15:52:09 GMT

Thanks Jason, very helpfull

Re: Cisco ISE Load on SNS-3615

Jessie Escobedo — Wed, 12 Feb 2020 17:30:39 GMT

Is 2.6 also come with the SNS-3655?

Re: Cisco ISE Load on SNS-3615

MEWO Cedrick — Thu, 13 Feb 2020 07:20:14 GMT

Hello Jessie,

In my knowledge all Cisco SNS-36X5-K9 comes with ISE already installed on it all you need is to apply the initial config to help you have control of device and deploy your solution as needed. You'll need below informations for initial setup

- IP Address

- DNS information

- NTP information

- Admins credentials.

- Etc.

But if you have any doubt you can confirm with your support or reseller.