topic ISE Server initial set up in Network Access Control

ISE Server initial set up

Joe Della Valle — Wed, 28 Aug 2019 15:12:54 GMT

I'm in the initial set up of a secondary ISE server and need to go back to the user name field and change it, how do I go back? Is the a key stroke to do that?

Currently the cursor is in the Password field and I need to go back the the user name field.

Thanks..

Re: ISE Server initial set up

alex_dufresne — Wed, 28 Aug 2019 15:22:50 GMT

Hello,

There is not really any way to go back during the initial setup. Have you tried simply restarting the VM?

Alternatively, you could just rename the user once the setup is done. Although, it's much easier to simply restart the setup from scratch.

Re: ISE Server initial set up

Damien Miller — Wed, 28 Aug 2019 16:11:29 GMT

Control+C will restart the setup script again. You can't go back but you can start over assuming you haven't completed it.

You can also change the username from the CLI after the setup has completed.

Re: ISE Server initial set up

alex_dufresne — Wed, 28 Aug 2019 18:05:30 GMT

Wow, I didn't know that one could simply Ctrl-C out of the setup script!

I assumed that it was suppressed or discouraged, since there is a warning later on about not using interrupts (such as when the script builds the database).