topic Re: ISE2.4 : backup : failure using GUI and CLI stuck at 45% in Network Access Control

ISE2.4 : backup : failure using GUI and CLI stuck at 45%

Barracuda87 — Thu, 11 Apr 2019 09:56:49 GMT

Hi all,

i have a problem on a BK ISE. BK stuck at 45% via CLI and GUI:

XXX/admin# backup ISE-CONFIG repository XXXX ise-config encryption-key plain XXXXXXXX

% Internal CA Store is not included in this backup. It is recommended to export it using "application configure ise" CLI command

% Creating backup with timestamped filename: ...........................................

% backup in progress: Starting Backup...10% completed

% backup in progress: Validating ISE Node Role...15% completed

% backup in progress: Backing up ISE Configuration Data...20% completed

% backup in progress: Backing up ISE Indexing Engine Data...45% completed

Re: ISE2.4 : backup : failure using GUI and CLI stuck at 45%

Timothy Abbott — Thu, 11 Apr 2019 14:25:08 GMT

If the issue persists, please reach out to the TAC.

Regards,
-Tim

Re: ISE2.4 : backup : failure using GUI and CLI stuck at 45%

Barracuda87 — Fri, 12 Apr 2019 11:49:34 GMT

Hi Tim,

can't I check the reason from the logs?

thx

Anto

Re: ISE2.4 : backup : failure using GUI and CLI stuck at 45%

mhamburger — Sat, 21 Mar 2020 17:34:25 GMT

Did anyone find a resolution to this other that call TAC? Seems to be a common issue if you search other message boards. Same with the disk full issues with ISE but never a "real" resolution is offered.

Re: ISE2.4 : backup : failure using GUI and CLI stuck at 45%

Damien Miller — Sat, 21 Mar 2020 18:48:44 GMT

You can try to cancel the backup via the CLI prior to calling TAC. On the primary admin node enter the following;
application configure ise
use option "[24]Force Backup Cancellation"

Disk full issues are certainly a TAC case, you still since you need root access to fix it.