topic Re: ISE 2.6 - Enabling MUD Profiling in Network Access Control

ISE 2.6 - Enabling MUD Profiling

bholding — Fri, 05 Apr 2019 00:28:48 GMT

Hi All,

I’m hoping someone can shed some light on this for me. I am attempting to get our lab infrastructure configured to support MUD enabled endpoints. To do this I am navigating to Work Centers -> Profiler -> Settings and check the box against ‘Enable profiling for MUD’. What I am finding is that when I navigate away from this page, and then back to it, the ‘Enable Profiling for MUD’ box is un-checked. I can’t seem to enable this feature. I’m not sure if this is a cosmetic GUI issue or not. I have attached two screenshots to show what I am seeing (before and after). I have tested with both Chrome and Firefox, so I don’t think it’s a browser issue. Has anyone seen behaviour before? Am I missing a step somewhere?

Thanks in advance

Brad

Re: ISE 2.6 - Enabling MUD Profiling

hslai — Wed, 17 Apr 2019 23:51:59 GMT

Assuming yours an upgraded ISE setup, this looks like a bug associated with ISE upgrade. I just open CSCvp37981

Re: ISE 2.6 - Enabling MUD Profiling

bholding — Thu, 18 Apr 2019 01:29:01 GMT

Thanks for responding. Yes, it was an upgrade from ISE 2.4.

Re: ISE 2.6 - Enabling MUD Profiling

vinverma — Thu, 02 May 2019 14:26:25 GMT

This issue is not seen when you install 2.6 fresh (not upgraded)

For now, please use a fresh install of 2.6 for Configuring Mud.

We are investigating the upgrade path.