topic Re: Device Import : Empty TACACS Section in Network Access Control

Device Import : Empty TACACS Section

InTheJuniverse — Sun, 03 Mar 2019 11:19:22 GMT

Hello

I am trying to import devices into ISE 2.4, everything works fine except that the imported devices don't have any Authentication protocol selected (in my case TACACS), though the TACACS shared secret is imported!!

What am I doing wrong? Oh btw, I have exported few devices from ISE and using the same template for import.

Thank you.

Re: Device Import : Empty TACACS Section

Mark Elsen — Sun, 03 Mar 2019 14:11:32 GMT

- Check the discussion from the thread below :

https://community.cisco.com/t5/policy-and-access/import-network-devices-into-ise-2-4-authentication-protocol/td-p/3378317

Re: Device Import : Empty TACACS Section

InTheJuniverse — Mon, 04 Mar 2019 06:28:50 GMT

Thank you. I read that before posting and my issue was different.

I could import the devices without errors, but 'TACACS Authentication Settings' was unchecked as you can see in the screenshot.

Funnily enough, I had to set column AO "TACACS:Connect Mode Options:String (OFF|ON_LEGACY|ON_DRAFT_COMPLIANT)" to OFF in order to enable TACACS Authentication for import 🙂 🙂 🙂