https://community.cisco.com/t5/network-access-control/patch-install-deployment-version-2-0/m-p/3806937#M484936 <P>You could just remove the secondary node from the deployment, patch it and bring it back into the deployment.</P> Thu, 21 Feb 2019 16:31:22 GMT paul 2019-02-21T16:31:22Z https://community.cisco.com/t5/network-access-control/patch-install-deployment-version-2-0/m-p/3806683#M484935 <P>I have recently been upgrading client ISE devices, they were on 1.2! come accross an issue, but I think I know the answer , would just like some confimation.</P> <P>&nbsp;</P> <P>I had to put a patch on the 2.0 Deployment (2 nodes) as we were not ready to goto 2.4 just yet, the patch 7 i installed on the primary node, and then I noticed a sync error in deployment and it would not do a manual sync, I looked at the secondary node and noticed ahaa! no disk space left so the patch did&nbsp; not go on.</P> <P>&nbsp;</P> <P>I have now cleared the diskspace, would this cause the sync error? I am plannig on rolling back the patch and trying again as I now have the disk space. ?</P> <P>&nbsp;</P> <P>&nbsp;</P> Sat, 09 Mar 2019 03:13:14 GMT https://community.cisco.com/t5/network-access-control/patch-install-deployment-version-2-0/m-p/3806683#M484935 James Davies 2019-03-09T03:13:14Z https://community.cisco.com/t5/network-access-control/patch-install-deployment-version-2-0/m-p/3806937#M484936 <P>You could just remove the secondary node from the deployment, patch it and bring it back into the deployment.</P> Thu, 21 Feb 2019 16:31:22 GMT https://community.cisco.com/t5/network-access-control/patch-install-deployment-version-2-0/m-p/3806937#M484936 paul 2019-02-21T16:31:22Z