topic Re: ISE Clickatell Variables in Network Access Control

ISE Clickatell Variables

ryans2 — Fri, 15 Feb 2019 16:09:53 GMT

Is there any documentation around the variables that are usable within ISE for the url config / other parts of the portal. I was able to find “&to=$mobilenumber$” and “&content=$message$” through forum posts, but was wondering if there is a comprehensive document of the usable variables within ISE.

Thanks,

Ryan

Re: ISE Clickatell Variables

Jason Kunst — Fri, 15 Feb 2019 16:54:44 GMT

Did you see the SMS documents under http://cs.co/ise-guest

I will check more on this

Re: ISE Clickatell Variables

ryans2 — Fri, 15 Feb 2019 17:04:56 GMT

We did try to utilize that documentation however it appears that Clickatell changed the url on their side and we were not able to use the api.clickatell.com and had to use platform.clickatell.com and then play around with the variables to get it to work. Thats where the question came up as to if there was any documentation on the useable variables piece of this.

Re: ISE Clickatell Variables

hslai — Fri, 15 Feb 2019 17:08:16 GMT

CSCuy85134 adds $timestamp$

besides the two you pointed out. That is all.

Re: ISE Clickatell Variables

Jason Kunst — Fri, 15 Feb 2019 17:14:44 GMT

Thanks please ask the provider as we had it working with them. If they made change please share new documentation with them and work through TAC as well if needed.

Re: ISE Clickatell Variables

Jason Kunst — Mon, 18 Feb 2019 14:48:10 GMT

I am working with engineering but it may take a while. Would recommend the TAC route to start. Let us know if you open a case

Re: ISE Clickatell Variables

Jason Kunst — Wed, 20 Feb 2019 13:14:45 GMT

our engineering said it works fine with platform. instead of api. are you having problems utilizing this or just a general question if there are any other variables available?

Re: ISE Clickatell Variables

ryans2 — Wed, 20 Feb 2019 13:42:56 GMT

I have it working it was just general question if we have any documentation I can pass on for variables available.

Re: ISE Clickatell Variables

Jason Kunst — Wed, 20 Feb 2019 13:49:06 GMT

The only added variable is the dynamic timestamp as mentioned

Re: ISE Clickatell Variables

ryans2 — Wed, 20 Feb 2019 13:52:17 GMT

Awesome thank you.