topic Re: Reconfigure ISE Interface Gateway address ??? in Network Access Control

Reconfigure ISE Interface Gateway address ???

Beacon Bits — Thu, 06 Dec 2018 10:19:14 GMT

Hello,

I have configured the wrong default gateway address during ISE installation.

How can I reconfigure the Gateway address from CLI?

CLI only gives IP address change option unless I missing something.

Regards,

Re: Reconfigure ISE Interface Gateway address ???

Arne Bier — Thu, 06 Dec 2018 11:13:30 GMT

example below with 192.168.0.1 as the default gateway

config t

ip default-gateway 192.168.0.1

You need to do this on the console because if you are ssh'd in, you will most likely lose your connection (unless you are ssh'd in from the same subnet of course) - just be careful 😉

Re: Reconfigure ISE Interface Gateway address ???

Beacon Bits — Thu, 06 Dec 2018 13:21:16 GMT

How could I miss that 😄

Thanks Arne.