https://community.cisco.com/t5/network-access-control/eapol-version-and-dot1x-version-on-a-catalyst-switch/m-p/3694668#M507982 <P>Enable&nbsp;all EAP-Types from the 'Allowed Protocols' for the authentication policy. This will let ISE accept any EAP types that is supported by ISE.</P> Fri, 24 Aug 2018 16:06:00 GMT howon 2018-08-24T16:06:00Z https://community.cisco.com/t5/network-access-control/eapol-version-and-dot1x-version-on-a-catalyst-switch/m-p/3694660#M507981 <P>We are testing an AXIS camera with dot1x&nbsp;that connects to&nbsp;a 3650&nbsp;switch.</P> <P>&nbsp;</P> <P>On the camera, we can only select version 2 EAPOL, but the switch is on dot1x version 3. the error always complains on the&nbsp;supplicant declining the EAP method proposed.&nbsp;</P> <P>11510 Supplicant declined EAP method selected by Authentication Policy...</P> <P>&nbsp;</P> <P>Is this the cause? or is this a problem on ISE side, or a problem with the certificate?</P> Fri, 24 Aug 2018 15:45:13 GMT https://community.cisco.com/t5/network-access-control/eapol-version-and-dot1x-version-on-a-catalyst-switch/m-p/3694660#M507981 harrzhan 2018-08-24T15:45:13Z https://community.cisco.com/t5/network-access-control/eapol-version-and-dot1x-version-on-a-catalyst-switch/m-p/3694668#M507982 <P>Enable&nbsp;all EAP-Types from the 'Allowed Protocols' for the authentication policy. This will let ISE accept any EAP types that is supported by ISE.</P> Fri, 24 Aug 2018 16:06:00 GMT https://community.cisco.com/t5/network-access-control/eapol-version-and-dot1x-version-on-a-catalyst-switch/m-p/3694668#M507982 howon 2018-08-24T16:06:00Z