topic Re: Testing Device SNMP config in Network Access Control

Testing Device SNMP config

Tim Glen — Wed, 09 May 2018 14:53:47 GMT

Hi,

In my network devices, I've configured SNMP creds for an IOS device. Is there a way I can test that the ISE nodes are successfully able to query SNMP on the IOS device?

Thanks

Tim

Re: Testing Device SNMP config

hslai — Wed, 09 May 2018 22:30:29 GMT

ISE does not have a test button for this. If debug snmp is on Cisco IOS device and/or TCPDUMP to capture the connections between ISE and NAD, we should be able to see the queries ~ 30 seconds after adding the SNMP configuration in the NAD and periodically based on the query interval setting.

Re: Testing Device SNMP config

paul — Fri, 11 May 2018 15:31:59 GMT

Hsing,

Craig actually posted a helpful tip that I was trying to find about doing SNMP testing from ISE. If you go to Context Visibility->Network Devices you can select a switch and then run Port Config Status. That should kick off an SNMP query to the switch.

Re: Testing Device SNMP config

hslai — Fri, 11 May 2018 16:17:40 GMT

Thanks a lot, Paul. I think you meant this -- ISE - Test SNMP Access to a Node