topic Re: Initial deployment ISE in Network Access Control https://community.cisco.com/t5/network-access-control/initial-deployment-ise/m-p/3436279#M518306 <HTML><HEAD></HEAD><BODY><P>You could use the other interfaces to separate RADIUS/TACACS from management or add an interface out into a DMZ for guest portals. </P><P></P><P>I typically delete all 6 E1000 interfaces and add back in one VMXNET3 interface.</P></BODY></HTML> Fri, 26 Jan 2018 15:02:54 GMT paul 2018-01-26T15:02:54Z Initial deployment ISE https://community.cisco.com/t5/network-access-control/initial-deployment-ise/m-p/3436278#M518305 <HTML><HEAD></HEAD><BODY><P>&nbsp;&nbsp;&nbsp;&nbsp; Good day,</P><P></P><P>I am totally new whith ISE solution, i have this concern, in the training section i see that the configuration in the ISE, just one interface is configured just the management interface, so, i see the appliance has 6 inrfaces, my question is, the other 5 interfaces what are these for</P><P></P><P>may is a stupid question, but as i say i am totally new, and i am the guy who has to installa the applaiance on cutomers</P></BODY></HTML> Fri, 26 Jan 2018 14:56:40 GMT https://community.cisco.com/t5/network-access-control/initial-deployment-ise/m-p/3436278#M518305 elmiguelo 2018-01-26T14:56:40Z Re: Initial deployment ISE https://community.cisco.com/t5/network-access-control/initial-deployment-ise/m-p/3436279#M518306 <HTML><HEAD></HEAD><BODY><P>You could use the other interfaces to separate RADIUS/TACACS from management or add an interface out into a DMZ for guest portals. </P><P></P><P>I typically delete all 6 E1000 interfaces and add back in one VMXNET3 interface.</P></BODY></HTML> Fri, 26 Jan 2018 15:02:54 GMT https://community.cisco.com/t5/network-access-control/initial-deployment-ise/m-p/3436279#M518306 paul 2018-01-26T15:02:54Z