topic Re: Registering of Secondary Fails in Network Access Control

Registering of Secondary Fails

Michael Voity — Sun, 21 Jan 2018 18:02:15 GMT

Hello,

I have recently installed 2 New 3515 ISE appliance servers.

Servers are both running 2.3.0.298.

Admin certs and FQDN names have been configured for both servers.

Licensing has been done with both s/n's via portal.

I have registered and deregistered 3 times and have rebooted the servers in between.

With out opening a tac case, Is there a way to see any logs on why they are failing, besides the canned error message?

The servers are separated by routed geography.

Ideas?

Michael Voity

University of Vermont

paul — Mon, 22 Jan 2018 19:48:53 GMT

Not sure if this would help but did you trying installing patch 1 on both nodes then join them together? Everything is NTP synced correctly?

Michael Voity — Mon, 22 Jan 2018 20:24:07 GMT

I will try Patch 1, These are brand new out of the box. NTP is setup correctly.

Thanks,

-Mike

Michael Voity — Mon, 22 Jan 2018 21:46:26 GMT

Patch 1 did the trick!

Thanks!

-Mike

paul — Mon, 22 Jan 2018 21:49:17 GMT

That is odd. I usually apply patch 1 after I get the deployment put together. Glad it worked.