topic Re: IOS XE (later releases) configuration examples for ISE integration in Network Access Control

IOS XE (later releases) configuration examples for ISE integration

hnohre — Fri, 15 Dec 2017 18:51:49 GMT

Can I have a pointer to IOS XE (Denali and later) configuration examples/guides for ISE integration?

Quite a few things has changed like IP device tracking config, debug RADIUS not working etc.

I found the ISE GOLD training example conf in the Bootstrap LAB very useful for legacy IOS switch configs

. Has that been updated?

Re: IOS XE (later releases) configuration examples for ISE integration

Craig Hyps — Sat, 16 Dec 2017 00:07:09 GMT

There are some sample IBNS 2.0 and 3850 config examples and guides here: https://communities.cisco.com/docs/DOC-64012#jive_content_id_Cisco_Switches

Re: IOS XE (later releases) configuration examples for ISE integration

hnohre — Sun, 17 Dec 2017 19:15:13 GMT

Thanks Craig,

I have read those documents, but I find them still out of date with the latest post-Denali releases of IOS.

Just some examples -

ip device tracking has disappeared completely from switch CLI, …. some release docs say it is turned on automatically if you enable a feature requiring it,

but I had to turn it on explicitly with device-tracking on the the interfaces

debug radius does not work at all, I also think other debug commands have changed

After having done I am sure 100+ switch configs with older versions of switch software, I am really suffering here. I thin these docs need to be updated.

Regards

Hakan