topic Re: Question on Universal Switch Config for ISE Guide in Network Access Control https://community.cisco.com/t5/network-access-control/question-on-universal-switch-config-for-ise-guide/m-p/3518265#M519826 <HTML><HEAD></HEAD><BODY><P>It depends on the host mode that is used on the interface. See (Last item):</P><P><A href="https://community.cisco.com/docs/DOC-72628">Top Ten mis-configured Cisco IOS Switch settings for ISE integration</A></P></BODY></HTML> Thu, 16 Nov 2017 04:43:11 GMT howon 2017-11-16T04:43:11Z Question on Universal Switch Config for ISE Guide https://community.cisco.com/t5/network-access-control/question-on-universal-switch-config-for-ise-guide/m-p/3518264#M519822 <HTML><HEAD></HEAD><BODY><P>On page 15, Step 8, the guide states the following:</P><P></P><P>SWITCH(config-if)#authentication event server dead action reinitialize vlan 10</P><P></P><P>I've always used 'authorize' and not initialize.&nbsp; Have a customer that followed this guide and TAC is also telling him it should be authorize.</P><P></P><P>Can you clarify?</P><P></P><P>Thanks.</P></BODY></HTML> Thu, 16 Nov 2017 04:16:34 GMT https://community.cisco.com/t5/network-access-control/question-on-universal-switch-config-for-ise-guide/m-p/3518264#M519822 scamarda 2017-11-16T04:16:34Z Re: Question on Universal Switch Config for ISE Guide https://community.cisco.com/t5/network-access-control/question-on-universal-switch-config-for-ise-guide/m-p/3518265#M519826 <HTML><HEAD></HEAD><BODY><P>It depends on the host mode that is used on the interface. See (Last item):</P><P><A href="https://community.cisco.com/docs/DOC-72628">Top Ten mis-configured Cisco IOS Switch settings for ISE integration</A></P></BODY></HTML> Thu, 16 Nov 2017 04:43:11 GMT https://community.cisco.com/t5/network-access-control/question-on-universal-switch-config-for-ise-guide/m-p/3518265#M519826 howon 2017-11-16T04:43:11Z