topic Re: ISE 2.2 SNMP trap for disk threshold not working in Network Access Control

ISE 2.2 SNMP trap for disk threshold not working

Gagandeep Singh — Wed, 02 Aug 2017 20:03:09 GMT

Hi Team,

I have recreated in my LAB ISE 2.2. Installed PRTG SNMP server on my laptop.

Ran a TCM DUMP on ISE and configured ISE for below configuration

snmp-server enable

snmp-server trap dskThresholdLimit "10"

snmp-server host 10.152.21.158 version 2c bm2read

snmp-server community bm2read ro

snmp-server engineID OHC9MKGF4E8

Attached PCAPs' with disk threshold set to "90" and "10".

Didn't see any SNMP Trap Events for Disk Utilization as described in guide. Do see other MIB events in SNMP packet.

Cisco Identity Services Engine Administrator Guide, Release 2.1 - Monitoring and Troubleshooting [Cisco Identity Servic…

OID	SNMP Trap
SNMP Trap Events for Disk Utilization
1.3.6.1.4.1.2021.9.1.9	UCD_SNMP_OID:dskPercent
1.3.6.1.4.1.2021.9.1.2	UCD_SNMP_OID:dskPath
SNMP Trap Notification for Process Status
1.3.6.1.2.1.25.4.2.1.2	HOST-RESOURCES-MIB:hrSWRunName

Any help would be appreciated.

Regards

Gagan

Re: ISE 2.2 SNMP trap for disk threshold not working

hslai — Wed, 02 Aug 2017 20:45:06 GMT

Please take a look at

ISE SNMP Trap - dskThresholdLimit - what is the OID?

Re: ISE 2.2 SNMP trap for disk threshold not working

Gagandeep Singh — Wed, 02 Aug 2017 21:37:46 GMT

Hi Hsing,

Thanks for the clarification.

I set the threshold to 99, still not seeing any disk utilization trap from ISE being send to SNMP receiver.

Is the bug still stand on the issue.

Regards

Gagan

Re: ISE 2.2 SNMP trap for disk threshold not working

hslai — Thu, 03 Aug 2017 00:33:45 GMT

This particular trap sends every 5 minutes. If you are unable to get it to work after waiting for an hour, please open an ISE ESC case, so our ESC team may take a look at your lab.