Best practise to monitor Cisco ISE

abdel.bidar — Mon, 22 May 2017 11:42:34 GMT

Hi,

We use IBM Netcool Omnibus to monitor our network. I am trying to figure out if anyone has deployed Cisco ISE in a production network and monitor it with IBM Netcool. The SNMP stack on the cisco ISE doesnt support many traps.

I may have missed something. I am not a Network engineer , I work on the monitoring development.

he SNMP Agent on Cisco ISE provides read-only access to the following MIBs:

SNMPv2-MIB
RFC1213-MIB(MIB II)
IF-MIB
IP-MIB
IP-FORWARD-MIB
TCP-MIB
UDP-MIB
HOST-RESOURCES-MIB
ENTITY-MIB —Three MIB variables are supported on the ENTITY-MIB:
- Product ID: entPhysicalModelName
- Version ID: entPhysicalHardwareRev
- Serial Number: entPhysicalSerialNumber
DISMAN-EVENT-MIB
NOTIFICATION-LOG-MIB
CISCO-CDP-MIB

Thank you

Abdel

Re: Best practise to monitor Cisco ISE

kthiruve — Tue, 23 May 2017 21:32:00 GMT

Hi Abdel,

Not sure what version of ISE you are running. Here is the information from ISE 2.2 on traps

Cisco Identity Services Engine Administrator Guide, Release 2.2 - Monitoring and Troubleshooting [Cisco Identity Servic…

Here i the information on MIBs and OID's supported

Cisco Identity Services Engine Administrator Guide, Release 2.2 - Supported Management Information Bases in Cisco ISE […

You can use SNMP poll for any SNMP manager to gather information from the MIBs.

Hope this helps.

Thanks

Krishnan

topic Re: Best practise to monitor Cisco ISE in Network Access Control

Best practise to monitor Cisco ISE

Re: Best practise to monitor Cisco ISE