topic ISE REST API functions for EPS ? in Network Access Control

ISE REST API functions for EPS ?

tuenoerg — Wed, 30 Nov 2016 15:41:13 GMT

Hi all,

One of our partners is trying to develop an application to list devices in quarantine (From FMC via PxGrid) and unquarantine them.

So I´m looking for a the REST API documentation for those features.

I have so far located :

I know I can use :

but - I can't find that documented anywhere.

Please point me in the right direction

Best regards

Tue

Timothy Abbott — Wed, 30 Nov 2016 15:46:04 GMT

Hi,

You have the correct document. Check out the ANC section:

Regards,

-Tim

Chess Norris — Fri, 02 Feb 2018 08:03:45 GMT

The API documentation mention above, is for the Adaptive Network Control (ANC).

Does any one know where to find similar API documentation for Endpoint Protection Service (EPS).

I am using Firepower Management Center to send API calls through pxGrid and FMC is using the legacy EPS feature.

In postman I have so far successfully tested the following API get calls:

Regards

/Jorgen

hslai — Fri, 02 Feb 2018 14:27:59 GMT

It's not documented at cisco.com. I believe it's due to EPS REST API is legacy and intended for small set of integration partners.