https://community.cisco.com/t5/network-access-control/posture-behaviour/m-p/3998981#M541056 <P>This is expected. If needed, apply some ACL to block the access to ISE.</P> Sat, 14 Dec 2019 23:10:29 GMT hslai 2019-12-14T23:10:29Z https://community.cisco.com/t5/network-access-control/posture-behaviour/m-p/3997826#M541021 <P>Hi,</P><P>&nbsp;</P><P>I am testing the Posture module for compliance check on a wired network and seeing strange behavior.</P><P>&nbsp;</P><P>&nbsp;I have added only one NAD (Switch) in ISE, No WLC(Wireless is integrated ). But WLC is connected in the same network and can ping ISE. Posture on Wired works fine.</P><P>why posture is running (Successful)when I connect to my wireless, even WLAN is not integrated with ISE. And I also see a session on ISE&nbsp;5200 Authentication succeeded</P><P>&nbsp;</P><P>Is it the right behavior.&nbsp;</P><P>&nbsp;</P><P><BR />Regards,</P><P>MD</P><P>&nbsp;</P> Thu, 12 Dec 2019 10:19:06 GMT https://community.cisco.com/t5/network-access-control/posture-behaviour/m-p/3997826#M541021 munish.dhiman1 2019-12-12T10:19:06Z https://community.cisco.com/t5/network-access-control/posture-behaviour/m-p/3998981#M541056 <P>This is expected. If needed, apply some ACL to block the access to ISE.</P> Sat, 14 Dec 2019 23:10:29 GMT https://community.cisco.com/t5/network-access-control/posture-behaviour/m-p/3998981#M541056 hslai 2019-12-14T23:10:29Z