topic Re: shutdown ise in Network Access Control

shutdown ise

kp-tkr2014 — Fri, 21 Feb 2020 18:57:51 GMT

Hi,

If I want to power off the ise appliance ,

Is it ok just run the command "application stop ise "

then manually power off the device ?

Thanks

Re: shutdown ise

Jatin Katyal — Thu, 07 Jun 2018 23:33:27 GMT

Imp > Before you shutdown the ISE node, take a configuration and operational backup.

The correct way to shut down an ISE node is
1. Application stop ise
2. Halt

halt :Disables or shuts down the Cisco ISE server.
https://www.cisco.com/c/en/us/td/docs/security/ise/2-3/cli_guide/b_ise_CLIReferenceGuide_23/b_ise_CLIReferenceGuide_23_chapter_011.html

Re: shutdown ise

kp-tkr2014 — Fri, 08 Jun 2018 00:53:25 GMT

Hi,

Configurational and operational backup always stuck at 20% .

even after upgraded multiple times .

Tried only configuration ,same problem .

By the way it is secondary node .

Thanks

Re: shutdown ise

ajc — Fri, 08 Jun 2018 15:03:22 GMT

Configuration and Operational Backup are ONLY created from Primary PAN

Re: shutdown ise

sonalivapilkar2197 — Sat, 25 Sep 2021 16:05:24 GMT

Could you also share the command to power on the application?

Re: shutdown ise

Marcelo Morais — Sat, 25 Sep 2021 23:25:16 GMT

Hi @sonalivapilkar2197 ,

to start ISE Application, use the:

ise/admin# application start ise

to check the ISE Application status, use the

ise/admin# show application status ise

For example:

ise/admin# show application status ise
ISE PROCESS NAME STATE PROCESS ID 
--------------------------------------------------------------------
...
Application Server running 16566
...

Hope this helps !!!

Re: shutdown ise

sonalivapilkar2197 — Sun, 26 Sep 2021 01:37:46 GMT

Hi @Marcelo Morais

Thanks, it helped. Anyhow, in my environment, when the VM was powered on the services were up and running again without any input from my side. Hoping this would help someone else!