topic Re: ip access-group not work between running Ath in Network Access Control

ip access-group not work between running Ath

billywaiclassmate — Fri, 21 Feb 2020 18:40:26 GMT

Hi All

I found the acl not work before my device during running auth

below is the ACL

interface command

AAA command

Would you have any suggest for me?

Thanks!

Re: ip access-group not work between running Ath

Karsten Iwen — Wed, 29 Nov 2017 11:49:12 GMT

Depending on the switch and version a "show ip access-list interface gig1/0/5" could shouw you the actually applied ACL. Looking at the config is not a valid check here.

And have you tried if there is really something different in place? Based on the shown output I would assume it works as expected.

Re: ip access-group not work between running Ath

billywaiclassmate — Wed, 29 Nov 2017 15:21:27 GMT

Thank for your reply!

when the interface running auth to show ip access-list interface gig1/0/5.

I can't found any ACL is running.

on then other hand, when auth is work, it can successful the download ISE's DaCL to interface and work.

Would you have any suggest to ip access-group was failed?

Thank for your help