https://community.cisco.com/t5/network-access-control/ise-max-user-session/m-p/3190838#M554694 <P>Is there also a way for wireless controller to send accounting stop on ISE as soon as the device get disconnected? Thanks!</P> Thu, 28 Sep 2017 07:48:09 GMT Mady 2017-09-28T07:48:09Z https://community.cisco.com/t5/network-access-control/ise-max-user-session/m-p/3190830#M554693 <P>Hi,</P><P>&nbsp;</P><P>I set&nbsp;our ISE maximum 1 session per user. I tested two devices with same username. First I connect the laptop and then mobile phone. Though I see on radius livelogs that it is working properly. Mobile device (2nd device) was unable to connect. But when I tried to disconnect the Laptop and connect the mobile instead, I can see that the mobile device still not allowed to connect due to max session per user.</P><P>&nbsp;</P><P>I would like to know if there is a setting on ISE or WLC that i need to modify for it to work vice versa (disconnect laptop then connect mobile device). It seems that when laptop was disconnected there's still session on WLC but on ISE context visibility it is already disconnected.</P><P>&nbsp;</P><P>Thank you for your help!</P><P>&nbsp;</P><P>~Mady</P> Fri, 21 Feb 2020 18:35:08 GMT https://community.cisco.com/t5/network-access-control/ise-max-user-session/m-p/3190830#M554693 Mady 2020-02-21T18:35:08Z https://community.cisco.com/t5/network-access-control/ise-max-user-session/m-p/3190838#M554694 <P>Is there also a way for wireless controller to send accounting stop on ISE as soon as the device get disconnected? Thanks!</P> Thu, 28 Sep 2017 07:48:09 GMT https://community.cisco.com/t5/network-access-control/ise-max-user-session/m-p/3190838#M554694 Mady 2017-09-28T07:48:09Z