topic ISE SNMP receiver in Network Access Control

ISE SNMP receiver

Roger Base — Wed, 13 Mar 2019 00:46:06 GMT

Hi.

I want to hear this forum about how the ISE can receive SNMP message from Swith or Router? I am interested to send LINKUP and LINKDOWN messages to my ISE server so I can monitor my SNMP messages from the ISE GUI or CLI. But I cannot find any documentation about how to setup this on ISE. The only thing I found about snmp for ISE is the profilling functionality.

Is this possible with ISE? If yes. How to ?

While up-down events are sent

jan.nielsen — Mon, 18 May 2015 18:28:24 GMT

While up-down events are sent to ise as part of the trustsec universal switch config, ise is not a network management/monitoring system, so you won't get very good use out of it for that.

SNMP probe is one among the

Venkatesh Attuluri — Thu, 21 May 2015 07:25:55 GMT

SNMP probe is one among the several probes that ISE use for profiling service. ISE is not meant for monitor functions its a radius server. Following link explains how ISE uses SNMP probe

http://www.cisco.com/en/US/docs/security/ise/1.0/user_guide/ise10_prof_pol.html#wp1341385