topic Re: GUI doesn't work in ISE in Network Access Control

GUI doesn't work in ISE

Ilnur.Garipov — Fri, 21 Feb 2020 18:51:48 GMT

Hello!
In the eve-ng virtual environment, I compile a simple network with ise-2.3. In the network are ise, switch and computer. ISE and the computer are on the same network, and I ran into the problem that I can not open the GUI, via a web browser. Although with this computer I can ping ise.
Has anyone encountered such a problem and what can be done in this situation?

Re: GUI doesn't work in ISE

nspasov — Mon, 26 Mar 2018 15:07:43 GMT

Hi there, a couple of questions:

1. Which interface in ISE has the mgmt ip?

2. What browser are you using

3. Have you tried HTTPs

Thank you for rating helpful posts!

Re: GUI doesn't work in ISE

Ilnur.Garipov — Mon, 26 Mar 2018 15:21:53 GMT

Hi,

Answer for you questions:

1. interface GigabitEthernet 0

2. Diferent: IE, Chrome and Mozilla

3. Yes, of course and negative

And when I write in CLI "show application status ise" I see that Application Server is initializing. And Application Server in this state all the time. So, I guess this is cause of problems.

Do you know how fix it is?

Re: GUI doesn't work in ISE

nspasov — Mon, 26 Mar 2018 15:23:48 GMT

Yeah, that was going to be my next question (Check the app status in CLI). Have you tried to force stop the ISE app and then force start it?

Re: GUI doesn't work in ISE

Ilnur.Garipov — Mon, 26 Mar 2018 15:35:35 GMT

Yep. More than once and result is still negative.

I start ISE in virtual environment EVE-NG, maybe this truble is connected with it?

Re: GUI doesn't work in ISE

nspasov — Mon, 26 Mar 2018 15:57:08 GMT

Perhaps, I don't use EVE-NG so I cannot test it but I have it running in my home lab (ESXi 6.5) without any issues. Perhaps, try re-deploying it.