topic Re: Static NAT in Network Access Control

Static NAT

onikaycee — Fri, 21 Feb 2020 19:04:27 GMT

I configured Static NAT for a server to be reached from outside environment but when i do a test, i see translation going on but the outside doesnt get to the server.

Re: Static NAT

Seb Rupik — Mon, 08 Apr 2019 09:41:51 GMT

Hi there,

Does the router have a route for the translated inside address?

Are there any ACLs along the path from the router to the server which could be denying the translated traffic?

cheers,

Seb.

Re: Static NAT

onikaycee — Mon, 08 Apr 2019 11:33:08 GMT

yes there is a route, then also there is no ACL denying it.

Re: Static NAT

Seb Rupik — Mon, 08 Apr 2019 12:20:56 GMT

Have you run a packet capture on the switchport the server is connected to, or the server itself to confirm that the server is not receiving the traffic.

What sort of traffic is it? What service is the server offering?

cheers,

Seb.

Re: Static NAT

Jason Kunst — Mon, 08 Apr 2019 14:42:28 GMT

This is for ISE anyconnect and ACS, i don't think you're in the correct community, perhaps firewall or routing?