AAA Group Issue

rakeshvelagala — Mon, 11 Mar 2019 05:42:20 GMT

I have below config on switch (C2960S-UNIVERSALK9-M), Version 15.0(2)SE7,

aaa group server tacacs+ testgroup
server name test1
server name test2
server name test3

tacacs server test1
address ipv4 192.1.1.1
key 7 testkey
timeout 3
single-connection

Similarly for test 2 and test3

Issue is, when the switch boots, it shows below message though all the authentication and autho is working properly.

Mar 25 01:19:10 UTC: %AAAA-4-NOSERVER: Warning: Server test1 is not defined.
Mar 25 01:19:10 UTC: %AAAA-4-NOSERVER: Warning: Server test2 is not defined.
Mar 25 01:19:10 UTC: %AAAA-4-NOSERVER: Warning: Server test3 is not defined.

Only reason I can think of is when the switch boots, it parses line by line and since the ip addresses of test1,test2,test3 are defined after the declaration, we are receiving this message? Can someone please advise?

Thanks

rakeshvelagala,Try config

gmagno001 — Mon, 04 May 2015 14:13:14 GMT

rakeshvelagala,

Try config with this command:

tacacs-server host x.x.x.x single-connection timeout 3 key 0 yyyyyyyyyy

Regards,

GUs Magno

This occurs as the "aaa group

Venkatesh Attuluri — Mon, 25 May 2015 12:18:29 GMT

This occurs as the "aaa group-server" commands are before the definition of "radius server name" in parser.

topic AAA Group Issue in Network Access Control

AAA Group Issue

rakeshvelagala,Try config

This occurs as the "aaa group