topic Re: login into sponsor portal with AD failed in Network Access Control

login into sponsor portal with AD failed

kaushalparab — Tue, 25 Feb 2020 07:43:35 GMT

login into sponsor portal with AD failed , In report - sponsor audit and login it shows failed reason as a - NO_SPONSOR_GROUP_MEMBERSHIP. But i have already assigned AD group into sponsor group where the admin belongs to and also the AD group has been added into AD -Groups field.

can suggest what could should be done?

when i created internal user with AD password then can able to login into sponsor portal but direct AD integration failed.

Re: login into sponsor portal with AD failed

Arne Bier — Wed, 26 Feb 2020 11:21:31 GMT

Hi @kaushalparab

i assume you have an identity source sequence that involves the correct AD join point(s) in which the user resides?

Depending on the version of ISE (and bugs) I have experienced a case where the PSN was not getting the config from the PAN. It meant that I was configuring until I was blue in the face, but my results were always the same. I had to do a manual sync and then the PSN suddenly did what it was supposed to.
You might want to share your config via screenshots and we can try help you

Re: login into sponsor portal with AD failed

Cristian Matei — Wed, 26 Feb 2020 13:15:10 GMT

Hi,

If your config is good and AD authentication works, the first thing i would do is apply the latest patch to ISE.

Regards,

Cristian Matei.

Re: login into sponsor portal with AD failed

thomas — Thu, 27 Feb 2020 15:33:28 GMT

I agree with Arne that more details are needed.

You may want to call TAC rather than troubleshooting in the forum.

Re: login into sponsor portal with AD failed

kaushalparab — Thu, 27 Feb 2020 15:38:25 GMT

I see. noted on your points . I'm working with TAC on this issue but seems India TAC is also having a bit struggle to test it out or not sure what is the issue as its been more delay to get the response back on this.

Thanks for your inputs will check on this with TAC.

Re: login into sponsor portal with AD failed

kaushalparab — Thu, 27 Feb 2020 15:39:06 GMT

Thanks ...already involved TAC ..lets see... 🙂